-
Notifications
You must be signed in to change notification settings - Fork 90
Rover Piksi Multi Firmware v1.2.14
kholtmann edited this page Dec 15, 2017
·
4 revisions
The following configuration assumes you are using UART 1 to plug Piksi to the on-board PC and an Xbee is attached to UART 0 of Piksi Multi.
Remember to adjust baudrate settings in ROS driver!
Each parameter "XXX.YYY" is located in the "Settings" tab of Swiftnav console, in section "XXX" and is called "YYY".
The following tables shows only the parameters that are different form the default ones, i.e. the ones you need to change!
| Parameter (Section Name) | Value | Description |
|---|---|---|
surveyed_position.broadcast |
False | do not survey a 'base station' position. |
uart0.enabled_sbp_messages |
0 | do not send anything over Xbee. |
uart0.baudrate |
115200 | baudrate Xbee. |
uart1.baudrate |
230400 | baudrate connection with on-board PC. |
Once you change uart1.baudrate then you will have to close and open the console again and used the new badrate: 230400.